Metabo KHE-D 28 Instrucciones de operaciones descargar pdf (Pagina 6)

ENGLISHen

For continuous operation the trigger can be locked

with the lock button (10). To stop the machine,

press the trigger again.

If switched on continuously, the machine

continues running if it is jerked out of

your hands. Therefore, always hold the

machine with both hands on the handles, stand

safely, and concentrate on your work.

6.3 Operating mode selection

Select the desired operating mode by turning the

control knob (13). To turn, push the stop (12).

twist drilling

hammer drilling

(only with use of hammer drill chuck)

chiselling

(KHE-D 28,

KHE-D 24

)

In chisel mode the chisel is locked to be twist-proof.

To position the chisel for the particular application,

set the control knob (13) between and

When a chisel is fitted, only operate the

machine in the chiselling operating

mode.

Avoid levering movements of the

machine when a chisel is fitted.

6.4 Selection of direction of rotation

Do not actuate the rotation selector

switch (9) unless the motor has

completely stopped.

Select direction of rotation:

R=clockwise

L = counter-clockwise

6.5 Drill chuck change (not KHE-D 24,

BHE-D 24)

When changing chucks make sure that

the spindle is clean. Grease spindle

lightly if required.

Removing the chuck:

Turn chuck lock (5) in direction indicated by arrow

against the stop (a) and pull it off the spindle (b).

Replacing the chuck:

Place chuck onto spindle (6) (a). Turn chuck lock (5)

in direction indicated by arrow (b) until chuck slides

fully onto the spindle, then release the chuck lock.

Check to see that the chuck is properly seated.

Note: To keep the spindle from turning while

changing chucks, set the control knob (13) to

chiselling.

6.6 Tool Change with SDS Chuck

Before fitting, clean tool shank and apply

special grease! Use only SDS-Plus tools!

Inserting the tool:

Turn the tool while inserting, until it engages. The

tool is automatically locked.

Removing the tool:

Turn tool lock (3) in direction indicated by arrow (a)

and remove the tool (b).

6.7 Tool change with Futuro Plus keyless

chuck (not KHE-D 24, BHE-D 24)

Insert tool. Grip the retaining ring (a) firmly and, with

the other hand, turn sleeve (b) towards "GRIP, ZU",

until the mechanical resistance which can be felt is

overcome.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comentarios a estos manuales

Sin comentarios

Metabo KHE-D 28 Instrucciones de operaciones Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Taladros Eléctricos Metabo KHE-D 28